Really?
Maybe this image will help. Had there been a safety rail it would have shown up on this enhanced photo.

Compared to this one.

Foto 16 shows less foliage than the other one.
However take a close look at the "overgrown pic". Look at the top rh corner of the rh buttress wall then continue sight line to the wall and "railing" there is a small round bush at low level. The lower coping level of the wall cannot be seen as it is covered in foliage in which the bottom stringer is hidden. Look closely to the right of the small bush and two vertical lines are just about visible at roughly the centres of the rails. At the bottom of these verticals one can just about make out the straight line of the bottom stringer. All IMO of course but asked to place a bet I would say the railings were never removed and what is the reason for no temporary barrier? apart from the usual IOTSMs ?
Anyway were it removed the act of removal would probably have been noticed by someone and maybe reported. I will not bore you with all the details, for once

, but even a simple job like that would not be done on spec unless of course you have some guy having a crack at it with a junior hacksaw just for a laugh. So there would have been a bit of toing and froing, noise and a few if not lots of sparks using some kit you will not be able to smuggle in under your duffel coat. Not to mention walking off site with a 20kg chunk of park railing ......
